Lab manual of pspice

PSpice Procedure Use PSpice to run an analysis of the circuit of Fig. 1. A model for the ‘ op-amp is given in Fig. 2. (The model in Fig. 2 is also available from the instructor on disk.) The actual circuit requires two V power supplies for the op-amp; the model in Fig. 2 works without having to explicity show these power supplies. Lab Manual For EE – Electronics Edited: 05/25/ Table of Contents Lab 1 (DIY): Introduction to PSpice Lab 2: Diode Characteristic and the Half‐Wave Rectifier Lab 3: Full‐wave Rectifiers and Power Supplies Lab 4: Bipolar Junction Transistor Characteristics Lab 5: BJT Common Emitter Amplifier Lab 6: Design and Characteristics of. Any two simulation experiments with PSPICE/PSIM PSPICE simulation of single phase full converter using RLE loads and single phase AC voltage controller using RLE loads. PSPICE simulation of resonant pulse commutation circuit and buck chopper. PSPICE simulation of single phase inverter with PWM control.

EE/CE Electronic Circuits Laboratory Spring Professor Y. Chiu 1 Lab 1: Introduction to PSpice Objectives A primary purpose of this lab is for you to become familiar with the use of PSpice and to learn to use it to assist you in the analysis of circuits. The software is already installed in the computer of every station. Electronic circuits Pulse Circuits Lab Manual. ECE,MIST. 10 6. In PSpice:Click the “Analysis” in the menu bar and then click “Setup” and select “AC Sweep” and set the starting frequency to 10 Hz and end frequency to 1 GHz and select radio button “Decade” and then close the box. PSPICE POWER ELECTRONICS LAB CONTENTS 1. Pulse-Width-Modulation (PWM) and Filter Characteristics 2. Switching Characteristics of MOSFET and Diode in a Power-Pole 3. Frequency Characteristics of Capacitors 4. Step-Down (Buck) DC-DC Converters 5. Step-Up (Boost) DC-DC Converter 6. Step-Down/Up (Buck-Boost) DC-DC Converter in CCM 7.

The circuit used is a JFET common-source amplifier. Pre-Lab. There is no pre-lab for this experiment. Equipment Needed v Current version of PSpice. 2. from Programs directory, click: OrCAD release 9, Capture CIS. OrCAD, in this laboratory, you will work through an example of each of the three. DC power supply using LM and LM Study of SMPS. SIMULATION USING SPICE. 1. Simulation of Experiments 3, 4, 5.